Ok, I am getting the Quick Time Eletronic Cutout to control the plates in my borla exhaust but I dont want to have switches everywhere in my car and I wont it pretty accessible.

The only time I open my windows independently is like at a drive through or toll booth or something, otherwise I am very **** for some reason, I open both windows to the same position.

Could I combine two window switches into one actualy switch so it controls both? Then I'd use the other switch to control the cutout, or I dunno.

Just throwing out ideas trying to figure out how to not clutter up my interior.

what do ya think.

 

It's a bad idea to combine the two window switches as you'll still be applying power to one of the motors while the window is not moving because it is at the end of the travel range.

 

exactly what i was thinking..
if one window is faster than the other.. you're screwed.

 

Your not the only one man, normally, its either windows all the way down, the same position(and i normally keep the window level with the top of the door and the window seal, so window is down a few inches)...

But yea, both windows cracked the same down to the seal, if not, both down, i cant stand the windows being at different hieghts, even when i had manual windows...

Im just glad im not the only one