Just got my 4th gen seats quickly installed in 84Z28. Drivers side=6way power, passenger=power lumbar. I quickly wired orange to hot and black to ground on the drivers side. I got a response on the forward switch but not on the two other switches. The orange and black wire were in front of the connector which was cut off before I received the seats. My question is do I have to do some sort of wiring to these other switches. I think so. Any help guys? Thanks for any and all suggestions and possibly and answer. I am really anxious to install these seats because I have been waiting 4 months for them to arrive here in Australia. I have gotten some really good help from you guys in the past. Thanks again.