87 iroc hatch
Thread Starter
Joined: Dec 2006
Posts: 219
Likes: 0
From: Southern NJ
Car: 01 Trans Am Ws6, 92 Camaro Rs
Engine: 6.0, 305
Transmission: T56,700R4
Axle/Gears: 3.90 9", 2.73 10 bolt
87 iroc hatch
I can't seem to get my iroc hatch to close if u slam it down it locks but its not down completely..i dont think its a pull down hatch because it just pops to open the hatch and it doesn't look like the same set up as my 92
Joined: Dec 1999
Posts: 5,964
Likes: 37
From: Hacienda Heights, CA
Car: 90 RS 'Vert, 88 IROC-Z, 88 Firebird
Engine: 305 ci tbi, 305 ci tpi, 350 ci tpi
Transmission: WC-T5, WC-T5, 700R4
Axle/Gears: 3.45, 3.27, 3.27
Re: 87 iroc hatch
https://www.thirdgen.org/tech/hatchpulldown.pdf
Start by downloading the tech article on repairing these hatch pull-down units. The reason why it looks different is that there was a completely different pull-down unit used in late 91-92 cars.
Unplug the red/white stripe wire from the blue wire and check that you have +12 v at that red/white stripe wire.
Lon
Start by downloading the tech article on repairing these hatch pull-down units. The reason why it looks different is that there was a completely different pull-down unit used in late 91-92 cars.
Unplug the red/white stripe wire from the blue wire and check that you have +12 v at that red/white stripe wire.
Lon
Thread
Thread Starter
Forum
Replies
Last Post
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM
