Need pics of jack area in trunk
Thread Starter
Senior Member
Joined: Apr 2003
Posts: 500
Likes: 0
From: Christchurch, New Zealand
Car: 1989 Trans Am
Engine: 1989 305 TPI
Transmission: 700-R4
Axle/Gears: 2.77 10 bolt
Need pics of jack area in trunk
Hi everyone,
I've just had a repair done to the outside of my car due to a smack in the right rear side. The bracket the factory jack attaches to however is bent and I can't remember if it was like this before the accident or it's meant to be that way.
Could someone please take a look at this picture and tell me if it's correct or not? If you could post a picture from your own car as to what it's meant to look like as well that would greatly be appreciated.
Thanks
I've just had a repair done to the outside of my car due to a smack in the right rear side. The bracket the factory jack attaches to however is bent and I can't remember if it was like this before the accident or it's meant to be that way.
Could someone please take a look at this picture and tell me if it's correct or not? If you could post a picture from your own car as to what it's meant to look like as well that would greatly be appreciated.
Thanks
Senior Member
iTrader: (1)
Joined: Oct 2008
Posts: 644
Likes: 1
From: Western Washington
Car: 86 T/A
Engine: 5.0 TPI
Transmission: 700R4
Re: Need pics of jack area in trunk
----------
Last edited by 1piece@atime; Oct 24, 2008 at 08:07 PM. Reason: Automerged Doublepost
Thread Starter
Senior Member
Joined: Apr 2003
Posts: 500
Likes: 0
From: Christchurch, New Zealand
Car: 1989 Trans Am
Engine: 1989 305 TPI
Transmission: 700-R4
Axle/Gears: 2.77 10 bolt
Re: Need pics of jack area in trunk
Thanks very much for those photos, greatly appreciated. 
Thread
Thread Starter
Forum
Replies
Last Post