Z28 High Rise Spoiler
Thread Starter
Member
iTrader: (8)
Joined: Jun 2006
Posts: 376
Likes: 2
From: Summerdale, AL
Car: 92 Camaro
Engine: El Tee Juan
Transmission: Tee five six
Axle/Gears: 10 Bolt 4:10's
Z28 High Rise Spoiler
I've had this Z28 high rise for a while now, pulled from another car I owned. I didn't drill holes and mount this spoiler on my car, but instead I just swapped out the deck lids on each car. Both were 92 Camaros. Anyways, what I am trying to figure out is how to align this new deck lid on my car. It sticks out about a center meter from the body, and does not line up horizontally, or vertically, almost like it has an overbite. How can I fix this?
Senior Member
iTrader: (1)
Joined: Apr 2004
Posts: 536
Likes: 0
From: Prescott Valley AZ
Car: 87 Iroc Showcar - Saturday Nite Hun
Engine: 383 4-Bolt Truck Hyd Roller MiniRam
Transmission: B&M 700R4 - Edge 3200
Axle/Gears: BW 9 Bolt-TA Cover & Stud Kit - 3.2
Re: Z28 High Rise Spoiler
I've had this Z28 high rise for a while now, pulled from another car I owned. I didn't drill holes and mount this spoiler on my car, but instead I just swapped out the deck lids on each car. Both were 92 Camaros. Anyways, what I am trying to figure out is how to align this new deck lid on my car. It sticks out about a center meter from the body, and does not line up horizontally, or vertically, almost like it has an overbite. How can I fix this?
know by changing a couple of them.
Body shop should be able to give you some tips for cheap.
Tweak damage maybe
Good luck
Later
Thread
Thread Starter
Forum
Replies
Last Post
