I've had this little hole in the driver's seat, and now it's getting bigger because of the metal wire that sticks me in the back every once-in-a-while.

How do I fix it? I want to fix the wire and patch the hole. I want it to be as cosmetically appealing as possible!

see the pictures:
http://www.umdnj.edu/~schirrjo/index2.html


------------------
86 IROC TPI 305
700-R4
K&N Air filters
Dyno-Max cat-back
Summit tranny cooler
CEI throttle enhancer chip
Trans-go shift kit

[This message has been edited by JoeIROC (edited May 07, 2001).]

 

i had the same thing happen to mine, altho mine wasnt very appearling, i just cut that damn wire(put holes in like 5 of my shirts), and sewed mine back together, i guess im just recommending cutting that damn wire, im not cosmetic man, duct tape would work for me
haha

 

Sew it back together. Nice hands, they're your girlfriends I hope. LOL

 

Yeah, I was holding the camera.

------------------
86 IROC TPI 305
700-R4
K&N Air filters
Dyno-Max cat-back
Summit tranny cooler
CEI throttle enhancer chip
Trans-go shift kit

[This message has been edited by JoeIROC (edited May 07, 2001).]

[This message has been edited by JoeIROC (edited May 07, 2001).]

 

just take it to an upholestry place or whatever you call them. they do the best work. Hope that helps.

 

Don't lie, they're your hands. Now come on, tell me where you get your nails done. :P

Rob

 

I found a cloth patch and some foam and stuffed the foam in there and then sowed the patch closed.. it works relatively well.. the foam keeps the damn wire from being a pest

------------------
92 Rs Heritage Edition Camaro
305
3.27 posi Rear end
Flow masters
not to much else to make it more than stock until I put that 350 in shortly

IM: DarkHal 2000
Feel free to join my Webring listed on my web page (X-treme Fbody). I'm always looking for third gen's to add.
My site, http://www.personal.psu.edu/users/j/m/jmj211/index.htm