What is required to adjust the rear hatch so it is flush with the rear fascia panel? I have noticed that most hatches stick out.

 

There is a tech article on this page which helped me out alot go to thirdgen.org/newdesign/tech/hatchalign.shtml I did it by myself but really wish I would have got help because it would have been a lot easier. It took me about 30 minutes to complete. Very happy with results. Great article!!!!!!!!! Good luck

 

Go to the tech article section and look for hatch realignment 101.

 

yea... that hatch is hella heavier than it seems with the supports in place. have a buddy or two handy when you do it.

 

IROCDetroit. . .
Thank you for the praise
Currently in Thailand (yeah...the country!) and popped on to check whats up.

Follow the article and you will have a beautifully aligned rear hatch!


E-mail me at wwixon@vinson.navy.mil for a laugh or to BS
------------------
Duffster (age 32)
BEAT DOWN HARD 88' Camaro Sport Coupe,
1978 Caprice Classic 305 motor havin'(WITH NO COMPUTER),Torker II intake, Edelbrock 1406,600cfm w/vacuum secondaries,Accel HEI Supercoil/Cap/Rotor Sparkin',84' POS 700R4 Tranny usin', 84' Z-28 Nose clip wearin',
84' Z-28 Hood covered,
AND THE TIRES:
245/60-16 Firehawk SS20 on Firbird rim(1-passenger rear),
235/55-15 BF Goodrich's on CompTA's on Z28 rims(2-on front),
235/60-16 Pirelli P600 w/a curb check or 3 also on Firebird rim(1-drivers rear),
REAR HATCH MASTER OF ALL!!!
DuffsterCamaro@HOME.COM
Owner of the Camaro 0 out of 10 Third-genners approve of, no longer part of the non-existent Iowa crew.

[This message has been edited by Duffster@Work (edited August 21, 2001).]

 

found a picture. . .