Does anyone have any instructions, tips, or advice on how to put the seats and interior of a 4th gen firebird to a 3rd gen firebird step bystep please e-mail me if you do or post your response thanks. chronicly @aol.com

4 bolts. That's as hard as it gets.

------------------

The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
Custom Thirdgen Subwoofer Enclosures
"I didn't know a bored out Ford could go so slow" -Shenandoah

Never done it in a Firebird, but my 94 Z seats fit with no problems into my 92 RS. 4 bolts on each seat and you are done. My drivers side was a power seat, so I had to run a power line to it. I just tapped into an un-usedn fuse spot in the fuse box, ran teh power wire under the carpet. I ran another wire for the ground (I attached that to a screw in the body), and hooked them up to the connector. Not very hard at all.

First, remove old seats.
Second install new seats.

Seats bolt right up with no modifications.
If the car had split rear seats like mine did, you will have that little bar underneath the new rear seat if it is a solid rear seat. I just painted that bar black so that you don't notice it.