Help. Best looking 4" cowl?
Thread Starter
Junior Member
Joined: Oct 2013
Posts: 72
Likes: 0
From: Tacoma, WA
Car: 1987 Camaro IROC-Z Z28
Engine: Custom Vortec 350
Transmission: 700R4
Axle/Gears: 3.73, Auburn Pro Series diff
Help. Best looking 4" cowl?
I have an 87' IROC-Z Z28 I need a cowl hood for. I want to go 4". I think most look badass, but I also have seen some really ugly ones! I was looking at the VFN fiberglass bolt on 4" and the Harwood 4" bolt on.
Any help or advice would be appreciated!!!!
Any help or advice would be appreciated!!!!
Senior Member
Joined: Sep 2012
Posts: 500
Likes: 9
From: Whitter, CA/La Puente, CA
Car: 1992 Z28 Targa Top. Full air ride
Engine: 305 5.0 tpi v8
Transmission: A4
Axle/Gears: 3.73 gears posi
Re: Help. Best looking 4" cowl?
I had a 4" Glasstek cowl on my 96' Camaro and loved it. If I didn't love the factory Z28 hood blisters on my current 92' so much I'd go back to Glasstek for another.
Thread Starter
Junior Member
Joined: Oct 2013
Posts: 72
Likes: 0
From: Tacoma, WA
Car: 1987 Camaro IROC-Z Z28
Engine: Custom Vortec 350
Transmission: 700R4
Axle/Gears: 3.73, Auburn Pro Series diff
Re: Help. Best looking 4" cowl?
Yeah I think I'm pretty set on the VFN fiberglass bolt on 4" now after reading reviews of VFNs products
Supreme Member
iTrader: (25)
Joined: Feb 2006
Posts: 7,260
Likes: 5
From: Manteca,California. Nor Cal.
Car: SOLD IT. Mopar guy only now.
Engine: gone
Transmission: gone
Axle/Gears: gone
Re: Help. Best looking 4" cowl?
shouldn't you install the cowl hood that looks best to you and not to others?
Member
iTrader: (2)
Joined: Feb 2010
Posts: 460
Likes: 3
Car: '89 Camaro
Engine: LS1
Transmission: 4L65/70E
Axle/Gears: 9 Inch, 3.70 gears
Re: Help. Best looking 4" cowl?
Here's the Harwood, I can't remember if it was 3" or 4", but I can tell you that it was bolt on. This was 10 years ago, and that car is long gone. I can tell you that the cowl did impare visibility a bit, but not too bad.
Thread
Thread Starter
Forum
Replies
Last Post