Door Jamb
Thread Starter
Member
Joined: Nov 2010
Posts: 162
Likes: 0
From: Raleigh
Car: 1989 Iroc Z 5.7L
Engine: 5.7L
Transmission: T56
Axle/Gears: built 4.10s
Door Jamb
I have always hated the 4 rusty screws in the door jamb, the screws holding the side ground effects. Curious if any one has replaced these screws and if anyone has drilled weep holes. Any good fixes?
Joined: Jun 2012
Posts: 114
Likes: 0
From: Howard County, MD
Car: 1987 Trans Am GTA
Engine: Warmed over 350 TPI
Transmission: 700r4 soon to be t56
Re: Door Jamb
On my GTA last week, I took the screws out, sanded, and painted them flat black. The black looks nice on the white.
Oh, don't forget to clean the dirt and grime out of the holes the screws sit in. Mine had a lot of crud packed in each slot.
Oh, don't forget to clean the dirt and grime out of the holes the screws sit in. Mine had a lot of crud packed in each slot.
Member
Joined: Jun 2006
Posts: 385
Likes: 5
From: WI
Car: 89 Trans am
Engine: 5.7 TPI
Re: Door Jamb
When I reassembled the my Trans am after the repaint I put new screws in there. Its something no one but you will ever notice, much less point out, but if it bothers you just put some new screws in. Tada! 
Thread
Thread Starter
Forum
Replies
Last Post