The madness has begun!!!!
Joined: Aug 2013
Posts: 4,807
Likes: 905
From: MICHIGAN
Car: 1988 Trans Am
Engine: L03
Transmission: 700R4
Axle/Gears: 10 Bolt 2.73 Open
Re: The madness has begun!!!!
A good start.
Are you doing this work...is that you in the photo? If so, you have a nice shop at your disposal.
Are you doing this work...is that you in the photo? If so, you have a nice shop at your disposal.
Senior Member
iTrader: (-1)
Joined: Oct 2008
Posts: 809
Likes: 1
From: Siloam Springs AR.
Car: 1998 Trans/Am, 1989 RS Camaro
Engine: LS1, LQ9 6.0
Transmission: 4L60E, 4L60E
Axle/Gears: 2.73, 2.73
Re: The madness has begun!!!!
damn. Aint playing around with the filler.
Thread Starter
Junior Member
Joined: Aug 2014
Posts: 9
Likes: 0
From: Tomball, TX
Engine: 350
Re: The madness has begun!!!!
No, I am not doing the body work. I am disassembling everything for my buddy to do the metalwork. I am a collision estimator at a dealership in houston. We have everything we need to get any job done but we stay extremely busy so we only get to work on it a little at a time. As for the filler, final product in the photos is 5 swipes of filler I think. Should be pretty damn straight when done. We are gonna strip every panel to bare metal and repeat the process. Bought $320 of Primer today. Looking to prime and block it 2 times.
Thread
Thread Starter
Forum
Replies
Last Post