Installing Hawks Wrap Around Spoiler
#1
Senior Member
Thread Starter
Join Date: Jan 2009
Location: DE
Posts: 611
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1990 Firebird Formula
Engine: LB9 - 5.0 TPI
Transmission: 700R4
Axle/Gears: 2.73, LSD
Installing Hawks Wrap Around Spoiler
I've read quite a few posts on installing these spoilers. I'm going to test fit and hopefully install this weekend. My question is this: do the clips at the end of the spoiler simply screw in to the spoiler? And my third brake light - does is screw into the spoiler too? I have no pre-drilled holes. I'm thinking about using small self-tapping screws.
#2
Supreme Member
iTrader: (1)
Join Date: May 2015
Location: Temecula, CA
Posts: 1,149
Received 83 Likes
on
67 Posts
Car: 1989 Pontiac Formula 350
Engine: L98
Transmission: 700R4
Axle/Gears: BorgWarner 3.27 Posi
Re: Installing Hawks Wrap Around Spoiler
Had to use self tappers on my Classic Industries one. I pre-drilled pilot holes though. I'll probably look into putting some epoxy in the holes as the screws try to back out occasionally.