Torque Specs for 1LE Fronts
Thread Starter
Joined: Aug 1999
Posts: 19,282
Likes: 103
From: Lawrence, KS
Car: Met. Silver 85 IROC/Sold
Engine: 350 HO Deluxe (350ci/330hp)
Transmission: T-5 (Non-WC)
Axle/Gears: Limited Slip 3.23's
Torque Specs for 1LE Fronts
Since Dan Burke's site is down (temporarily, I hope), I need the specs. An old post says 137 carrier to adapter and 85 or so for adapter to spindle, but members were waffling a bit on the numbers.
JamesC
JamesC
Guest
Posts: n/a
Supreme Member
iTrader: (7)
Joined: Mar 2001
Posts: 6,420
Likes: 5
From: Fort Mill, SC, USA
Car: '88 Iroc, '91 RS, and a '70 RS
Engine: 5.7 TPI; 5.0 TBI; ZZ4/T56 on the ag
Transmission: A4, A4, slated to be a T56
Non need to go all the way to 137# on those bolts, especially if you use the factory bolts with the threadlocker on them. 50-70# is fine with a threadlocker, I thought 137# was a bit high when I did mine.
Ed
Ed
Supreme Member
iTrader: (7)
Joined: Mar 2001
Posts: 6,420
Likes: 5
From: Fort Mill, SC, USA
Car: '88 Iroc, '91 RS, and a '70 RS
Engine: 5.7 TPI; 5.0 TBI; ZZ4/T56 on the ag
Transmission: A4, A4, slated to be a T56
Re: Torque Specs for 1LE Fronts
Bump to top..
Ed
Spindle mods are in the Wilwood instructions here:
http://www.wilwood.com/BrakeKits/Pages/08/index.asp
Ed
Spindle mods are in the Wilwood instructions here:
http://www.wilwood.com/BrakeKits/Pages/08/index.asp
Last edited by ebmiller88; Mar 28, 2007 at 05:23 PM.
Thread
Thread Starter
Forum
Replies
Last Post
