Does anyone have any outside dimensions for a sub box that will fit into the rear of a 89 IROC w/ a power hatch?

------------------
Owner of a 1989 IROC-Z Camaro, a.k.a. "The Babe Magnet". Painted a cheap metallic blue that chips off all too easily and covers over the IROC-Z decals on the doors, also has non-leaking T-tops, ps, pw, power rear hatch, working A/C. Mods: SLP intake runners, gutted MAF sensor, adjustable fuel pressure regulator, modified air spoil, 3.27 posi rear end.
Broken stuff: rear spoiler brake light, driver side lock, power antenna, tilt steering, rear end bushings, cracked passanger side ground effect, washer fluid tab, leaking exhaust and a rotted through muffler that sparks when the car bottoms out while driving like any 17 year old does.

 

There really isn't a nice simple answer on the dementions. There are alot of angles, and small peices you have to incorperate to get a nice box. Some place will make you a box that is all square, and doesn't really conform to the well. But this site here has all the dementions. For some of the pieces it is a little hard to decipher but it will help you get a start. For any piece you can't figure out just get a tape mesurer and go to your cars well. Anyways, good luck. http://members.nbci.com/_XMCM/catdogg/speaker.htm

------------------
1988 Pontiac Trans Am GTA
350 tpi, Fully Stock
BEST ET 15.4

Stereo
Alpine CDA-7864
Power Acoustik Apache Series 2200 watt amp
Two MTX Thunder 8000's in Thirdgen Box

 

thats a good link. hats off!