Do You Need To Prime A Mech Fuel Pump?
Thread Starter
Member
Joined: Jan 2006
Posts: 393
Likes: 0
From: Central Alberta,Canada
Car: 88 Iroc Vert/ 1980 Z28
Engine: 305 TPI/ 350
Transmission: 700R4/ TH350
Axle/Gears: 2.73posi/ 3.08 Open
Do You Need To Prime A Mech Fuel Pump?
I changed the pump on my 81 1/2 ton and it isn't flowing anything. I think I got the rod in place correctly.
Member
iTrader: (1)
Joined: Dec 2004
Posts: 239
Likes: 0
From: FLORIDA
Car: 86 CAMARO
Engine: 92-350 +.030
Transmission: 86-th400
Axle/Gears: 3.73
not usually. but if all the gas ran out of your fuel lines it may take a bit of cranking to get it flowing again. if you want disconnect line from carb and use a small funnel and pour a little gas in it to fill lines.
Thread Starter
Member
Joined: Jan 2006
Posts: 393
Likes: 0
From: Central Alberta,Canada
Car: 88 Iroc Vert/ 1980 Z28
Engine: 305 TPI/ 350
Transmission: 700R4/ TH350
Axle/Gears: 2.73posi/ 3.08 Open
I must not have cranked it enough yesterday because I came out this afternoon and it started flowing after a few cranks.
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
