Fan Wiring
#1
Member
Thread Starter
iTrader: (2)
Join Date: Mar 2002
Location: Lowell, In
Posts: 346
Likes: 0
Received 1 Like
on
1 Post
Car: 1991 Chevy Camaro RS
Engine: 350 TPI
Transmission: 700R4,
Axle/Gears: 3.73 w/SLP Zexel Torsen Limited Sli
Fan Wiring
Ok so I did a TPI swap on my RS and am trying to wire up my dual fans. I put a SP setup on from a 90 Bird(I was told that is what it came off of).
I have 2 wires i think are for my fans one is black w/ red and the other is black w/orange. They are just siting on the pass side fender right now. they have no connector on them. do they go right to the fan or do they go to a relay. I would like to have my fan control through the ecm, but don't know how to wire this up.
where would the fan relay be located? did all tpi have dual fans or is it posssible that this only came with 1 and I will have to wire 1 in separately? I have looked at wiring diagrams but don't see the black w/orange wire on any and see the black/with red comeing from a realy but these wires don't seem to becoming from a relay they go into the wiring bundle(no clue were they go after that) but i have only added 1 more relay to my setup which was the fuel pump relay. SO what am I missing here?
Thanks for any help.
This is the last thing to do before I get her back on the road fo rover 5 years now so I am kinda getting anxious.
I have 2 wires i think are for my fans one is black w/ red and the other is black w/orange. They are just siting on the pass side fender right now. they have no connector on them. do they go right to the fan or do they go to a relay. I would like to have my fan control through the ecm, but don't know how to wire this up.
where would the fan relay be located? did all tpi have dual fans or is it posssible that this only came with 1 and I will have to wire 1 in separately? I have looked at wiring diagrams but don't see the black w/orange wire on any and see the black/with red comeing from a realy but these wires don't seem to becoming from a relay they go into the wiring bundle(no clue were they go after that) but i have only added 1 more relay to my setup which was the fuel pump relay. SO what am I missing here?
Thanks for any help.
This is the last thing to do before I get her back on the road fo rover 5 years now so I am kinda getting anxious.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM