DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

W h a t ??

Thread Tools
 
Search this Thread
 
Old Jul 6, 2005 | 10:46 PM
  #1  
vorgath's Avatar
Thread Starter
Supreme Member
 
Joined: May 2005
Posts: 1,701
Likes: 0
From: San Diego, CA
Car: 1991 Camaro RS
Engine: LO3
Transmission: 700R4
Axle/Gears: 3.42 LS1
W h a t ??

OK, quick question here ... besides the obvious need for skill.. knowledge .. (reading a lot on this forum) ... to make a performance chip for a 305 TBI ... from 1991 ... I would need:

http://www.moates.net/product_info.p...products_id=48

and

http://www.moates.net/product_info.p...products_id=39


What else ? Besides a comp.. which I of course have *l*
Reply
Old Jul 8, 2005 | 06:18 AM
  #2  
RBob's Avatar
Moderator
iTrader: (1)
 
Joined: Mar 2002
Posts: 18,432
Likes: 233
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
Will need a data logger, cable and an editing utility. For logging use WinALDL, it is a free utility that will data log the ALDL stream to your laptop. Cable can be made or purchased. Editing software can be purchased (TunerCat) or free (TunerPro).

RBob.
Reply
Old Jul 8, 2005 | 04:37 PM
  #3  
vorgath's Avatar
Thread Starter
Supreme Member
 
Joined: May 2005
Posts: 1,701
Likes: 0
From: San Diego, CA
Car: 1991 Camaro RS
Engine: LO3
Transmission: 700R4
Axle/Gears: 3.42 LS1
That's it ??

As far as equipment goes .. that's .. it ?

How much will that all cost .. 150 ?
Reply




All times are GMT -5. The time now is 05:00 PM.