Need help scanning sensors!
Thread Starter
Member
iTrader: (1)
Joined: May 2002
Posts: 186
Likes: 0
From: Philadelphia, PA
Car: '88 Camaro
Engine: v6-173-2.8L
Transmission: Automatic
Need help scanning sensors!
I need to run diagnostics to figure out what sensors are bad. I have an aldl cable and tunerpro and winaldl, but I have no idea how to use them. I have a 2.8 ecm 1227302. Any help would be greatly appreciated.
Moderator
iTrader: (1)
Joined: Mar 2002
Posts: 18,432
Likes: 233
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
The basics of it are: plug the cable into the ALDL port under the dash, start up WinALDL on the PC/laptop, give it a definition file for the '7302 ECM, turn on the key and you should have data.
Not sure about where to find the '7302 defintion file. It may be on Joby's site, or moates.net/fileman.
RBob.
Not sure about where to find the '7302 defintion file. It may be on Joby's site, or moates.net/fileman.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
HoosierinWA
Tech / General Engine
5
Oct 7, 2015 10:15 AM