computer in a 1986 Iroc tuned port, question
computer in a 1986 Iroc tuned port, question
was wondering if anyone knew if or how i can change my computer in my Iroc to accept the six speed that i would liek to put in it?
it currently has a 700R4 so if i take out the auto there will be alot of infor mation the computer will not be getting correct?
Please advise!
it currently has a 700R4 so if i take out the auto there will be alot of infor mation the computer will not be getting correct?
Please advise!
Moderator
iTrader: (1)
Joined: Mar 2002
Posts: 18,432
Likes: 233
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
Re: computer in a 1986 Iroc tuned port, question
Most likely you can leave the current ECM/MEMCAL in place. Going from an auto to a stick trans is not as critical as going the other way. Try it and see how it runs.
Depending upon the engine a later vehicle MEMCAL (see sticky's) could be used. There are no calibrations for a 350 & stick trans. So if it is a 305 you could change the MEMCAL to a 305/5sp calibration. Any from '86 through '88 will work. In '89 the cold start injector went away and VATS came on board.
RBob.
Depending upon the engine a later vehicle MEMCAL (see sticky's) could be used. There are no calibrations for a 350 & stick trans. So if it is a 305 you could change the MEMCAL to a 305/5sp calibration. Any from '86 through '88 will work. In '89 the cold start injector went away and VATS came on board.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM
