more questions
Thread Starter
Junior Member
Joined: Dec 2002
Posts: 62
Likes: 0
more questions
Hello again o mighty ones...
I have more questions please..
ecm 7730, bin aujp1615.
1. when adjusting the main spark tables.. is the number shown in each cell the amount the computer is going to add to the initial distributor setting or will it be the total spark advance including the initial.. also when is say PE spark.. will it then add that much more to the main spark table? I looking to relate these numbers to old school thinking that 34 to 36 degrees total timing is usually close to max for pump gas..
I have more questions please..
ecm 7730, bin aujp1615.
1. when adjusting the main spark tables.. is the number shown in each cell the amount the computer is going to add to the initial distributor setting or will it be the total spark advance including the initial.. also when is say PE spark.. will it then add that much more to the main spark table? I looking to relate these numbers to old school thinking that 34 to 36 degrees total timing is usually close to max for pump gas..
Thread
Thread Starter
Forum
Replies
Last Post
