Using SD 730 ecm and associated def file I can connect tunerpro to my ecm but the data stream is very slow or maybe non existent. Only a couple parameters seem to be working, coolant temp, timing, ect.
Works fine with 165 ecm. What setting am I missing?

 

I'm using TunerPro with my '165 ecm and Prominator on a Win2000Pro laptop.

I see a delay in the data stream when I connect the aldl. Perhaps 1-1/2 to 2 seconds. Example---rev car, wait a couple moments, then tach on "dash" of TunerPro finally goes up.

I can connect with my old Win98 laptop with the Craig Moates free software and the "lag" is almost non-existant.

Both computers using the exact same cable set-up.

I figured it was a delay where the aldl info has to go through the TunerPro program, but it would be nice if there was not as much delay. This still happens even if the Prominator cable is disconnected. It is not that big of a deal but kind of annoying.

Also, Mangus, would it be possible to put more "dashboard" info in the next update?

For reference, look at the old Craig Moates download on page 4 (summary of critical values).

Just my brief experience as I get deeper into tuning with my Prominator.

Thanks,
jms