Guys I read the artice posted about the equipment need to burn chips and that there are a few sites that have the needed pieces.1
What exactly do u need to buy , how much , and can some one that doesnt know too much about computers ,burn their own chips? Where can u find out what each BIN stands for? The entire reason I am asking this is I have a supercharged 305tpi , that i am sure could gain alot from a custom chip. I would rather build it for my needs and rust in myself ,or should I have some else do it for me? Any info would be very usful thanks

 

Please read the tech article in the tech section of thirdgen.org ....

Programming PROMs for your Thirdgen Fuel Injected F-Body: Part I Introduction

Tim


------------------
TRAXION's 1990 IROC-Z
Best Time = 12.244 @ 112.51mph (1.778 60' / 7.819@88.32mph in the 1/8)
All Natural. No Force. No Drugs. Stock Bottom End. Stock Body Panels.
Gunning for NA 11's after installing Hooker LT Headers and reducing weight.
-=ICON Motorsports=-
Moderator: PROM board at thirdgen.org