scanner software
scanner software
Could you guys tell me what you guys think about different scanner software. I am looking at software that will work with sd. I liked the way that datamasters demo looks, it is a nice windows based program, but I dont know if it has as many outputs as diacom. Any suggestions about these or others welcome.
Thanks
Ben
Thanks
Ben
I am using Easy and like it a lot.
With it you can record as long as you have hard drive space, I recorded the drive home from work one night and it takes me 20 min to get home.
92 Z/28
go here
http://www.obd2.com/personal/personal_gmobdi.htm
[This message has been edited by Z_Ghost (edited December 07, 2001).]
With it you can record as long as you have hard drive space, I recorded the drive home from work one night and it takes me 20 min to get home.
92 Z/28
go here
http://www.obd2.com/personal/personal_gmobdi.htm
[This message has been edited by Z_Ghost (edited December 07, 2001).]
I have looked at their site, it looks really nice. What are the system requirements. Also, how long can you record with diacom and datamaster. Does anyone have experince with more than one of them so they can compare?
Senior Member
Joined: Jul 1999
Posts: 786
Likes: 2
From: Guilford, NY
Car: 1988 IROC-Z
Engine: 350 TPI
Transmission: 700R4 w/TransGo
Axle/Gears: BW 9-bolt w/3.73s
I also use the scan tool from Ease, it is very nice. See my response on the other post for scanner VS Diacom software.
It will work on any decent Windows based PC. I use a 266Mhz laptop to run the scantool, then take the data and move it to my desktop PC, it is a bit faster. Helps with the graphics.
------------------
Best ET 14.413 @95.57 without
pulling valve covers or manifolds.
Also with stock 2.77 rear end!!!
It will work on any decent Windows based PC. I use a 266Mhz laptop to run the scantool, then take the data and move it to my desktop PC, it is a bit faster. Helps with the graphics.
------------------
Best ET 14.413 @95.57 without
pulling valve covers or manifolds.
Also with stock 2.77 rear end!!!
Thread
Thread Starter
Forum
Replies
Last Post




