I just recieved my ALDL cable that I bought from CamarosRus. I downloaded and installed the proper drivers for the cable. It is a USB cable w/ the 10k resistor for my 89 Formula 350 TPI. I have the com port setup properly, however when I open up TunerProRT and WinALDL, i get no data whatsoever. TunerProRT says it cannot detect any hardware. I'm about to smash my head into a brick wall, can someone help me out, or do did I buy a bunko cable?
Senior Member
Cflick
Senior Member
close
Apr 29, 2020
- Join DateJun 2007
- LocationAkron, Ohio
- Posts:600
- iTrader Positive Feedback0
- iTrader Feedback Score(0)
- Car87 Suburban 2500
- Engine455 Wildcat ( somewhat modified ))
- TransmissionTH400 ( for now )
- Axle/Gears4.10 ( for now )
- Likes:0
- Liked:0 Times in 0 Posts
Since you mention winaldl, I'll assume the "driver" sets up the cable as a com port.
Open hyperterm ( or whatever M$ calls it these days ) and connect directly to that port.
Do you see garbage from the ECM ?
If so, the cable is fine.
If not, that doesn't necessarily indicate that it's bad, just indicates what I don't know about your system.
Open hyperterm ( or whatever M$ calls it these days ) and connect directly to that port.
Do you see garbage from the ECM ?
If so, the cable is fine.
If not, that doesn't necessarily indicate that it's bad, just indicates what I don't know about your system.