modding $0D for IAT/MAT
Thread Starter
Member
Joined: Sep 2006
Posts: 420
Likes: 0
modding $0D for IAT/MAT
can someone give me a QUICK rundown on what I need to read/software to get for doing this?
I know I need to learn how to read hex and all that, I think I'm gonna step off into this stuff. The end goal is the above stated, $0D with IAT/MAT.
How will the formulas fit into the code?
I know this is a pretty big endeavor to start, but I just need someone to give me the quick once-over on writing code (if that's possible).
I'm experienced with tunerpro, just not the hex part.
I know I need to learn how to read hex and all that, I think I'm gonna step off into this stuff. The end goal is the above stated, $0D with IAT/MAT.
How will the formulas fit into the code?
I know this is a pretty big endeavor to start, but I just need someone to give me the quick once-over on writing code (if that's possible).
I'm experienced with tunerpro, just not the hex part.
Joined: Jan 2005
Posts: 10,450
Likes: 508
From: Hurst, Texas
Car: 1983 G20 Chevy
Engine: 305 TPI
Transmission: 4L60
Axle/Gears: 14 bolt with 3.07 gears
Re: modding $0D for IAT/MAT
The Functionality is already there in the Code, just set the option flag, and fill in the tables with the CPI 4.3 settings. That will get you close enough to be able to fine tweak the settings.
