trying to tune out off-idle stumble
Thread Starter
Senior Member
Joined: Sep 2009
Posts: 354
Likes: 1
From: Manchester,PA
Car: 86 Firebird SE
Engine: 2.8L
trying to tune out off-idle stumble
I am trying to figure out how to tune out an off idle stumble i have. I cant figure out which table has control over TPS tip-in. Its code mask $32B. Anyone have any ideas? When you start pressing the gas theres a stumble then it goes. Thats the only area that its running poorly. Hopefully someone has some good input on what table to look at. I cant find anything in my searches of the forum. Also what would the "use LV8 for BLM not dispflow" do? Well if i knew what dispflow was id already know lol.
Member
iTrader: (10)
Joined: Aug 2005
Posts: 418
Likes: 0
From: Ocean Springs, MS
Car: 1987 Monte Carlo SS
Engine: HSR 383 AFR180/268XFI EBL
Transmission: 200-4R, Edge 2800 L/U
Axle/Gears: 7.5/3.73/PowerTrax No-Slip
Re: trying to tune out off-idle stumble
Have you done any data logging to show what is happening during tip-in?
