Does anyone use Dataman S4?
Thread Starter
Junior Member
Joined: Oct 2007
Posts: 17
Likes: 0
From: Chattanooga, TN
Car: 87 GTA
Engine: 385 Stroker
Transmission: T5
Axle/Gears: 3.45 9 bolt
Does anyone use Dataman S4?
One of my friends gave me one of these units, and I have it all set up, and talking to my lap top.
I edit a bin with tuner pro using the 6e.xdf definition, and save the bin, then open it with the dataman software, and send it to the dataman programmer. When I try to burn the chip, it keeps giving me a message when it gets to a certain byte that says "same". I am using the 27c128 chips.
The instruction book doesn't say how exactly to do this. I would also like to use a at29c256 chip, but again, the instructions doesn't say how to burn the bin to the lower/upper half of the chip.
If anyone uses this thing, if you don't mind giving me a "step by step" on it, I would really appreciate it.
I edit a bin with tuner pro using the 6e.xdf definition, and save the bin, then open it with the dataman software, and send it to the dataman programmer. When I try to burn the chip, it keeps giving me a message when it gets to a certain byte that says "same". I am using the 27c128 chips.
The instruction book doesn't say how exactly to do this. I would also like to use a at29c256 chip, but again, the instructions doesn't say how to burn the bin to the lower/upper half of the chip.
If anyone uses this thing, if you don't mind giving me a "step by step" on it, I would really appreciate it.
Thread Starter
Junior Member
Joined: Oct 2007
Posts: 17
Likes: 0
From: Chattanooga, TN
Car: 87 GTA
Engine: 385 Stroker
Transmission: T5
Axle/Gears: 3.45 9 bolt
Re: Does anyone use Dataman S4?
Well, I guess no one uses this unit, so I bought the moates burn2, and few eeproms to play with. 
