Asynch Question
Asynch Question
EBL
To enable Asy I see Asy trans high. I have at zero. I should move to 1000 usec?
Asy low(to disable?) I have at zero I should move to 650 ?
Max Asy PW I am at 1700 uSec
Min " " 650 "
Low RPM to exit high load Asy I should move to 3600?
" MAP " " " " " " " " " 75?
High RPM to enter high load Asy I should move to 3650?
" MAP " " " " " " " " " 80?
Is this close to correct?
To enable Asy I see Asy trans high. I have at zero. I should move to 1000 usec?
Asy low(to disable?) I have at zero I should move to 650 ?
Max Asy PW I am at 1700 uSec
Min " " 650 "
Low RPM to exit high load Asy I should move to 3600?
" MAP " " " " " " " " " 75?
High RPM to enter high load Asy I should move to 3650?
" MAP " " " " " " " " " 80?
Is this close to correct?
Re: EBL Asynch Question
EBL
To enable Asy I see Asy trans high. I have at zero. I should move to 1000 usec?
Asy low(to disable?) I have at zero I should move to 650 ?
Max Asy PW I am at 1700 uSec
Min " " 650 "
Low RPM to exit high load Asy I should move to 3600?
" MAP " " " " " " " " " 75?
High RPM to enter high load Asy I should move to 3650?
" MAP " " " " " " " " " 80?
Is this close to correct?
To enable Asy I see Asy trans high. I have at zero. I should move to 1000 usec?
Asy low(to disable?) I have at zero I should move to 650 ?
Max Asy PW I am at 1700 uSec
Min " " 650 "
Low RPM to exit high load Asy I should move to 3600?
" MAP " " " " " " " " " 75?
High RPM to enter high load Asy I should move to 3650?
" MAP " " " " " " " " " 80?
Is this close to correct?
Thread
Thread Starter
Forum
Replies
Last Post