Ok I read the tech article on burning your own chips & really want to get started on doing my own.... I'll be starting off w/ TBI chips before I do my TPI swap, I have a good knowledge of computers & a very basic knowledge of playing w/ code... So is it really as ez as everyone says it is?? Wheres the best place to get all the stuff that a person needs to get started ordering off the internet or places like radio shack? What are the best programs to use?

Thanks,

-Timbo-

 

Back on the main page there is a link to articles.. Read the one on burning chips.. It has all the info you need

As far as how easy it is? I don't know.. I started with the ARAP BIN and it was pretty much how I needed it.

My whole project started because my stock chip got corrupted.. Then my geek side took over and now I am burning chips

Do minor changes 1 at a time and see the results.. Get scanning software! This whole time I have been doing it blind