Software Needs For Programming?
Thread Starter
Senior Member
Joined: Aug 2001
Posts: 627
Likes: 0
From: Stafford CT
Car: 1988 Camaro SC
Engine: LT1 SBC
Transmission: LT1 T56
Axle/Gears: 3.73 Moser 12 Bolt
Software Needs For Programming?
What exactly is needed to program your own ECM? I've looked into the JEGS/Summits/ect... and have come up decidedly empty handed - where do you guys get your stuff (particularly for TBI)?
TP
TP
Supreme Member
Joined: Jun 2000
Posts: 7,554
Likes: 1
From: In reality
Car: An Ol Buick
Engine: Vsick
Transmission: Janis Tranny Yank Converter
Re: Software Needs For Programming?
Originally posted by TP355Z
What exactly is needed to program your own ECM? I've looked into the JEGS/Summits/ect... and have come up decidedly empty handed - where do you guys get your stuff (particularly for TBI)?
TP
What exactly is needed to program your own ECM? I've looked into the JEGS/Summits/ect... and have come up decidedly empty handed - where do you guys get your stuff (particularly for TBI)?
TP
Personally, I stick with Tundercat or GMEpro stuff
www.tunercat.com
or
terry
E-mail Address(es):
terry_kelley@hp.com
GMEPro is DOS oriented and perfect for running on your cheap laptop. So you can have a laptop set up for scanning, and if you want to do some in car prom burning just throw your pocket programmer in the car and away ya go.
Both the Tunercat and GMEPro have very complete 42 mask editing. GMEPro has an optional 42 for using with the lean cruise patch of the 747, as I recall
TGO Supporter
Joined: Jul 1999
Posts: 10,907
Likes: 4
From: The Bone Yard
Car: Death Mobile
Engine: 666 c.i.
Read this --> https://www.thirdgen.org/newdesign/tech/promintro.shtml
Supreme Member
Joined: Jul 1999
Posts: 1,577
Likes: 0
From: Baton Rouge, LA, USA
Car: 87 T/A
Engine: 441 SBC 12.5:1 0.680" Lift
Transmission: T-56
Axle/Gears: 4.10 TruTrac Moser 9"
Is there an update coming on the FAQ/Intro? I mean, there's not even any mention of 29C256 chips among other things. I know an update was discussed, just didn't know if it was in the works or what.
Thread
Thread Starter
Forum
Replies
Last Post