Questions about wiring another Tach
Thread Starter
Banned
Joined: Jun 2001
Posts: 2,228
Likes: 1
From: Lan Terminal
Questions about wiring another Tach
NO I'm not asking how to hook one, up if I had one I'd read directions.
Here is my question, I just recently installed a new Gauge cluster and while playing with the old one I noticed how the tach and gas and temp gauges are hooked in. They have those screws coming outta them and they just snap in place. So could I take my old tach, and run some leads from the current one and hook it to the old one??
Would this possibly work? Then I could just get a 5 inch cup to mount it in.
Thoughts? Answers??
------------------
un4givin89
Here is my question, I just recently installed a new Gauge cluster and while playing with the old one I noticed how the tach and gas and temp gauges are hooked in. They have those screws coming outta them and they just snap in place. So could I take my old tach, and run some leads from the current one and hook it to the old one??
Would this possibly work? Then I could just get a 5 inch cup to mount it in.
Thoughts? Answers??
------------------
un4givin89
Supreme Member
Joined: Jul 1999
Posts: 1,335
Likes: 2
From: Tucson, AZ, USA
Car: '92 Z28; Dk Teal; Her Pkg
Engine: 305
Transmission: Richmond 6 Spd
Axle/Gears: Moser 9", Detroit Locker, 3.70
I would think that it would work. The tach gauge has power, ground, and tach inputs, and paralleling two tachs should not be a problem.
------------------
Tim
1992 Z28, 305 TPI 5 speed, 12.0 sec @ 114.8 mph
1984 Berlinetta 305 TPI Auto, 13.8 sec @ 99.7 mph
------------------
Tim
1992 Z28, 305 TPI 5 speed, 12.0 sec @ 114.8 mph
1984 Berlinetta 305 TPI Auto, 13.8 sec @ 99.7 mph
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
