Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

how can you test if a relay is good or not??

Thread Tools
 
Search this Thread
 
Old Oct 13, 2003 | 05:48 PM
  #1  
grafx's Avatar
Thread Starter
Supreme Member
 
Joined: Nov 2001
Posts: 1,160
Likes: 0
From: So. California
Car: 91 Camaro RS
Engine: 305 TBI
Transmission: Pro-Built Automatic/Vigilante 2800
how can you test if a relay is good or not??

I want to know if the relay for my door locks needs replaced or not. They still lock but act sort of sluggish.
Reply
Old Oct 13, 2003 | 06:38 PM
  #2  
onebinky's Avatar
Supreme Member
iTrader: (1)
 
Joined: Apr 2001
Posts: 2,031
Likes: 0
From: Southwest Chicago 'burbs
if they still work, the relay is doing it's job. If the locks are getting sluggish, you probably need to clean your lock linkages in the door. Find all the points that contact each other when you lock and unlock. Spray them down with WD-40 to get all the dirt and gunk off of them, and then spray all of it with a white lithium grease to lubricate them. In between those two stages, work the locks back and forth quite a few times to work the lube in. You might as well lube the window tracks and regulator while your in there too.

Good luck,
Matt
Reply
Old Oct 14, 2003 | 08:31 PM
  #3  
Maverick H1L's Avatar
Supreme Member
iTrader: (8)
 
Joined: Aug 2003
Posts: 7,240
Likes: 6
From: LeRoy, NY
Car: 2003 Hyundai Tiburon GT
Engine: 2.7L V6
Transmission: 6-speed
Axle/Gears: 4.41
What binky said . I had the same problem except worse: The passenger side door lock did NOT work AT ALL. Part of the problem was that someone f***ed with the door and put that lock **** on the INSIDE of the door panel and trim, and the other was that the weatherstripping on the outer side of the window and the inner plastic was no good and let water into the door panel, rusting the whole darn thing into place. A good half hour is what it took me to get that thing working again...
Reply
Old Oct 15, 2003 | 08:00 AM
  #4  
Jim85IROC's Avatar
TGO Supporter
iTrader: (2)
 
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
There was a discussion a few months ago that revolved around the relay ground on the kick panel. A few people mentioned that their door locks were very sluggish, and thought it was their linkage. After cleaning up the relay ground, their their power locks came back to life.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BRoss99
Electronics
28
Aug 10, 2025 05:08 PM
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
RazorN8
Tech / General Engine
4
Jan 7, 2022 11:44 AM
Caspar
TPI
24
Jun 19, 2016 11:19 PM




All times are GMT -5. The time now is 03:31 AM.