Installing Tach Question
Thread Starter
Member
Joined: Mar 2007
Posts: 270
Likes: 0
From: Michigan
Car: 87 camaro
Engine: 357 swap
Transmission: t5
Axle/Gears: 3.42
Installing Tach Question
I am installing a tach in my IROC dash cluster (factory one). Everything else works fine and I believe all my wiring on the cluster is all set and good ready for the tach but where is the best place to pick it up in the engine bay to mount to distributor?
Supreme Member
Joined: Jul 2005
Posts: 2,123
Likes: 0
From: North Central Mass.
Car: 1985 Berlinetta
Engine: Megasquirted TPI
Transmission: Transgo 700R4
Axle/Gears: 3.42
Re: Installing Tach Question
Negative terminal of the coil.
What distributor (external coil? coil in cap?)
The coil in cap HEI have a "tach" output on the side. The external coils use a white wire ont he negative side of the coil
What distributor (external coil? coil in cap?)
The coil in cap HEI have a "tach" output on the side. The external coils use a white wire ont he negative side of the coil
Thread Starter
Member
Joined: Mar 2007
Posts: 270
Likes: 0
From: Michigan
Car: 87 camaro
Engine: 357 swap
Transmission: t5
Axle/Gears: 3.42
Re: Installing Tach Question
Wheres the best place to pick up white wire at? Original v6 wiring was cut out
I got an HEI dist.
I got an HEI dist.
Last edited by stevenb; Oct 8, 2007 at 09:43 PM.
Supreme Member
Joined: Jul 2003
Posts: 2,779
Likes: 2
From: any clime or place...
Car: 1987 Camaro SC, 1999 Z28
Engine: GMPP 350HO, LS1
Transmission: Built 700r4/EDGE 3200, T56
Axle/Gears: 3.42 Eaton 7.625, 3.42 Zexel Torsen
Re: Installing Tach Question
i don't think i'm following the previous question?
Thread
Thread Starter
Forum
Replies
Last Post
