OK, this is kinda of an in-depth electical issue. But any helpfull theories will deffinatly be appreciated.

The cluster gauges are controlled by the motors seen here.




To re-assemble the cluster, I need to know where to point the needles when i re-attach them.

My thought, is to give it a specific voltage, so then i know exactly where the needle should be pointed. BUT, i don't know the voltage values. I cannot find any part numbers on the gauge motors either.

The only thing i can think to do is get a another cluster, in a running camaro, swap clusters and try to match the needles. but that is going to be really difficult.