Hey guys Im in the process of a swap on my 1992 Camaro it was originally a 3.1 v6 auto I put in a 5.0 v8 and auto trans from another 1992 Camaro that was the easiest part the hard part is putting the new wiring harness on the car can anyone give me any tips and tricks to make the job easier

Havent done this swap exactly but i have done lots of wiring. Mark every connector so you know where it belongs. Be extra careful around bulkheads and hinge points that can rub or pinch, use grommets through firewalls. If you have any areas where its hard to fish wires through you can feed scrap wire/string from opposite side, tie off the new wires and gently pull the harness through. Check all connectors are clean before you begin.

Thanks a lot! Little scary for me not a big wire guy but it's gotta get dine it's the like whole tbi wire harness lll