12v accessory power for my cluster
Thread Starter
Junior Member
Joined: Nov 2016
Posts: 5
Likes: 0
From: Colorado Springs, CO
Car: 1989 IROC
Engine: 350 TPI
Transmission: 700r4
Axle/Gears: 3.73
12v accessory power for my cluster
Installing a new cluster in my 89 and I need a 12v accessory power. The kit says to use the fuse box, but I can't find any open areas that does accessory (used a light tester with the key in the ON position, no luck) anyone know of any wires I can piggy-back, or should my fuse box have an open slot?
Thanks
Thanks
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Dash 4 cash
There should be terminals in your fuse block labeled BAT.
You can connect a fuse it.
OR
They sell fuses with pigtails on them in which you can use that fuse.
Just make sure you select the correct side so if the fuse blows power will be cut.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing !
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Don’t Fuss Paintin’ Your Back Bumper, Cause B4 The Race Is Over I’m Gonna Be Pushing You Out Of The Way
You can connect a fuse it.
OR
They sell fuses with pigtails on them in which you can use that fuse.
Just make sure you select the correct side so if the fuse blows power will be cut.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing !
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Don’t Fuss Paintin’ Your Back Bumper, Cause B4 The Race Is Over I’m Gonna Be Pushing You Out Of The Way
Joined: Mar 2001
Posts: 10,421
Likes: 2,083
Car: '89 Firebird
Engine: 7.0L
Transmission: T56
Re: 12v accessory power for my cluster
The original cluster wiring has a switched power source. It is the PNK/BLK wire at the brown connector.
https://www.thirdgen.org/forums/ltx-...ml#post6111293
https://www.thirdgen.org/forums/ltx-...ml#post6111293
Joined: Mar 2001
Posts: 10,421
Likes: 2,083
Car: '89 Firebird
Engine: 7.0L
Transmission: T56
Re: 12v accessory power for my cluster
Oops, sorry, I just noticed you have a Camaro not a Firebird. Nothing I said applies to you.
Although, the same concept must be true, you just have to find the wire.
Although, the same concept must be true, you just have to find the wire.