Building a serious 305, start here
Thread Starter
Joined: May 2001
Posts: 364
Likes: 2
From: WI north
Car: 88 Firebird
Engine: 302 SBC
Transmission: T-5
Axle/Gears: 4.27 Dana 44
Building a serious 305, start here
305 roller cam block and rotating assembly with all new parts and fully balanced.
New KB pistons for use with 350 vortec heads and gaskets, 9.5 compression.
New Eagle SIR rods
New crank, all std sizes
All new rings, plugs and bearings throughout
All shop work done: cleaned, measured, bored .030, honed, balanced and assembled.
Finish your way with your choice of cam, heads, intake, etc.
THIS IS NOT A STOCK LEVEL ASSEMBLY. This one costs more. This is for someone needing to build something more powerful and durable than stock. This one can be bought for less than starting yourself from scratch.
Send me an email for more details.
New KB pistons for use with 350 vortec heads and gaskets, 9.5 compression.
New Eagle SIR rods
New crank, all std sizes
All new rings, plugs and bearings throughout
All shop work done: cleaned, measured, bored .030, honed, balanced and assembled.
Finish your way with your choice of cam, heads, intake, etc.
THIS IS NOT A STOCK LEVEL ASSEMBLY. This one costs more. This is for someone needing to build something more powerful and durable than stock. This one can be bought for less than starting yourself from scratch.
Send me an email for more details.
Thread Starter
Joined: May 2001
Posts: 364
Likes: 2
From: WI north
Car: 88 Firebird
Engine: 302 SBC
Transmission: T-5
Axle/Gears: 4.27 Dana 44
92HeritageT~Top
I am going to need some way to email you. I am getting undeliverable messages when I try to get the info to you.
I am going to need some way to email you. I am getting undeliverable messages when I try to get the info to you.
Junior Member
Joined: May 2004
Posts: 65
Likes: 0
From: Tyler, TX
Car: 92 Heritage T-Top
Engine: 350
Transmission: 5-Speed
Ok, try sending to Stuie444@hotmail.com Let me know if you still have problems...
Thread
Thread Starter
Forum
Replies
Last Post