400SBC in W. Michigan
Thread Starter
Senior Member
iTrader: (1)
Joined: Jul 2005
Posts: 624
Likes: 0
From: SW Michigan
Car: '88 G T/A
Engine: L98
Transmission: 700R4
Axle/Gears: 3.27 9 Bolt
400SBC in W. Michigan
2 Bolt main 400sbc, standard bore. I have block, main caps, flexplate, crank, balancer, stock rods and pistons, oil pan, timing cover. Won't ship, located in west Michigan (south of grand rapids).
$250
The bores do not have much of a ridge at the top, nor are they rusted in any way. The motor sat in a machine shop for 10years with heads, intake and carb on it, never opened until I bought it and took the top end off, as well as disassembled the short block for a rebuild. They should clean up at .030", I wouldnt go any more then that with a 400.
Casting number is 511, which is a 4Bolt casting normally, however it was a warranty replacement motor, so it is a 2 bolt main, pretty rare.
Moretec:
"3951511....400...70-73...4...Some replacement blocks had 2-bolt main caps"
$250
The bores do not have much of a ridge at the top, nor are they rusted in any way. The motor sat in a machine shop for 10years with heads, intake and carb on it, never opened until I bought it and took the top end off, as well as disassembled the short block for a rebuild. They should clean up at .030", I wouldnt go any more then that with a 400.
Casting number is 511, which is a 4Bolt casting normally, however it was a warranty replacement motor, so it is a 2 bolt main, pretty rare.
Moretec:
"3951511....400...70-73...4...Some replacement blocks had 2-bolt main caps"
Last edited by MattODoom; Feb 18, 2007 at 04:57 PM.
Thread
Thread Starter
Forum
Replies
Last Post
tyler84ta
Engine/Drivetrain/Suspension Wanted
2
Feb 20, 2011 05:42 AM