Chevy 350 1 piece rear seal 4 bolt main roller block
Engine has about 300 miles on it:
Scat 1 piece steel 5140 rear seal 383 crank
Eagle 5.7 5140 rods w/ arp rod bolts
Speed Pro rings and .030 oversize 383 forged aluminum full floating pistons
Clevlite bearings
ProTopline 200/64cc aluminum heads with 7/16 studs and 2.02/1.60 valves
Scorpion (rebranded Harland Sharp) 1.5 roller rocker with poly locks
Edelbrock RPM Air Gap intake
Edelbrock 750 performer carb
Custom Crower roller cam reground on a small base circle - 222/230 @ .050 - .536/.549 lift with 1.5 Rockers
Mini starter
1 wire alternator
Serpentine belt setup with A/C compressor
Headman shortie headers
Milodon oil pan
Hi pressure oil pump
ALL ARP bolts throughout
tall Aluminum valve covers
K&N Air Filter 14x3 and K&N xtreme lid
Lokar throttle/TV cables as well as oil dipstick
MSD 85551 distributor & Blaster II coil

I had the shortblock built by Hitch's in Maryville, TN.

and a th2004r trans

need to get $3k for all of it so I can start my next project. I am in Sevierville, TN.