I have a Used set of Bare pro-topline heads for SBC, 220CC/72CC CNC Combustion chambers machined for 2.02/1.60 vales. I bought them used had them resufaced and pressure checked,used them for 300 miles way to big for my set up. $450 part# 2232800201. will get pics later

 

Heres the pics

 

Flow @ .600 lift? Or have you had them flowbenched?
Are they ported or gasket matched to any gaskets?
When you say to big, do you mean you did not have enough cam and stall to run them?

 

No porting has been done, intake port takes fel-pro 1206 gasket, according to RHS Flow chart thay flow 272 int. 190 exh. at .600 lift. I did not have enough cam,comp,stall.

 

Where are you located?

 

I am in Kansas.

 

Bump Bump need these gone $450 obo

 

Would trade for a good good 750-hp carb.

 

SOLD SOLD