I have a complete 305 engine from a 1988 IROC. Obtained the package a couple of years ago ...trading of course. The engine looks great, I have no mechanical history on it but did run the VIN through the state police to make sure it wasn't stolen. It was removed from a wrecked IROC, removed the pan...bottom ends looks great and clean.
I also have the OEM wiring harness, ECM and dual intake snorkel. Noticed that the plug on the MAF sensor is chipped...but should still work. Since I picked up this unit I obtained a few more TPI setups. Figure I would let this one go as a unit to someone trying to restore their 88/89 IROC?
I'll let the package go for $325...or trade it for a complete 5sp (T5/T56) setup for my 33 Chevy project.
Here is a link for a picture, the engine file name is IROC88:
http://www.putfile.com/33chevy/images/133392
I'm in Champlain, NY 12919, the upper most north east section of the state. Just south of Montreal, PQ, Canada and 2 miles from Vermont. (NY/Canada border)
My direct e-mail is: ziptow@yahoo.com
Again, I'd like to sell this package as a unit and not break it into parts (yet).
Ed
I also have the OEM wiring harness, ECM and dual intake snorkel. Noticed that the plug on the MAF sensor is chipped...but should still work. Since I picked up this unit I obtained a few more TPI setups. Figure I would let this one go as a unit to someone trying to restore their 88/89 IROC?
I'll let the package go for $325...or trade it for a complete 5sp (T5/T56) setup for my 33 Chevy project.
Here is a link for a picture, the engine file name is IROC88:
http://www.putfile.com/33chevy/images/133392
I'm in Champlain, NY 12919, the upper most north east section of the state. Just south of Montreal, PQ, Canada and 2 miles from Vermont. (NY/Canada border)
My direct e-mail is: ziptow@yahoo.com
Again, I'd like to sell this package as a unit and not break it into parts (yet).
Ed