Hey everyone,

I'm selling a set of complete Vortec Heads, Casting number 12558062 from a 1998 Silverado. They were working just fine when the engine was pulled two years ago and have been sitting on my garage floor ever since.

$400.00 plus shipping.

I'm also selling a 350 bare block, casting number 10243880. It's been honed, magnafluxed, cleaned and bored .030. This is a roller block from the same vehicle as the heads. I will include the receipt for the work already accomplished.

$450 plus shipping.

I would prefer not to ship due to weight. I am located in Clovis, NM. I do not have the numbers for shipping at this time however I will see what I can get if requested.

Attached are pictures of the block. It does have some surface rust on it because it's been sitting while I attempted to convince the wife to let me build it. I've decided to go in another direction as my indomidable will crashed and burned on her unmovable stance that I have better things to spend my money on.

 

are heads ready to be bolted up to the engine as is, and would they work with the tpi engine, if i get a vortec intake? also im located in hobbs so it wouldnt be a problem to pick them up

 

PM sent

 

For those that are curious the heads have been sitting in the garage unused for a little more than 2 years. They have some surface rust but otherwise are complete and were in good running order when pulled from the vehicle.

 

Is this a 4-bolt or 2-bolt block?

 

2-Bolt

 

So it hasn't been run since bored out .030"?

Were the mains aligned honed? Were the decks resurfaced?

 

Ah crap..nevermind. Just saw how far you are. Sorry.