1. holley carb 600 vac secondaries. bought it new for 325ish, had it on my motor to break it in and ran it about 2 weeks now paring the car back out, ran well on a 350 with a decent cam, visually perfect, 150 obo

2. old q jet that was on the 305 when i bought the car, some peices missing and things, not in the greatest shape but ran very well when i took it off the 305, 50 bucks obo

3. 350 4 bolt main block, its the high nickle content block with the 010 stamping, asking 150 obo

4. crank shaft that came from above engine, i believe its a forged piece, it rings when tapped with a hammer, and has a very wide forging line down the center, 100 obo

5. heads, one set which came off the above mentioned engine, and one set that came off the 305, never heard or seen the 350 run, but the 350 ran very well and did not smoke or burn oil, 100 obo per set

6. limited slip diff - came out of a 7 5/8 rear end, gears bolted to the diff are junked but the diff is in good shape 100 obo

7. 3.42 gear set for a 7 5/8 rear end, used but wear pattern is good and gears are in good shape 50 obo

8. turbo 350 trans, i ran the transmission for about 4 months while saving for my 700 to be rebuilt, shifts nice and the fluid was still nice when i drained it comes with converter 200 obo

9. used 700 r4, not positive what year it is but i was going to have it rebuilt but ended up buying my buddies that was already built, i believe it came out of van possibly 86? not sure.. comes with the converter 150 obo

10. stock used drive shaft from an 86 with a 700r4, just the drive shaft 50 obo

11. used stock torque arm greasy but in good shape, 35 obo

12. rear end from an 86 camaro, just the housing and axles, no differential
, good shape rusty but solid, and comes with 2 new axle seals and brake bads new, 150 obo




thats about it that i can think of right now, selling all this to build my next car so everything has to go, i can ship but would rather not with the bigger stuff, im in pa near sharon and butler, just make me an offer and i can take pics if someones actually interested in something, thanks guys

 

no one? im sure someone can use something?

 

need some more info on the 350 heads? combustions and valve sizes? im guessing there cast iron