Bought this off a member here several months ago and I never used it. He never used it either.

I was gonna put this on my 383 turbo build for 550-600whp but I decided to go with a larger motor and more power, and twin turbos

This is a great manifold for mild motors as it features a 2.5" sched 40 pipe with about a 2" ID feed tube which i feel is abit too small for a 383 or larger motor for over 600whp which I'm gonna be well over.
Primaries appear to be about 1 5/8 OD and are sched. 40 pipe. Real beefy setup.

So got to get rid of it. I kept it in case i couldnt fabricate these twin manifolds but i got them 90% done, so the BBS has to go.


T4 flange with 38mm wastegate flange.

Pittsburgh PA, looking to get 425 shipped. Let me know

 

Bump 400 shipped or best. Give me some offers, need gone to fund twin turbo project

 

My cousin called me last week asking me to make his friend twin turbo headers... I'll call him tomorrow and see if he'll settle for a single turbo. Was this for the V-belt or the serpentine belt accessory drive?

 

i have no idea actually. I can double check the fitment with my accessory bracket but i dont think a decent T4 turbo will clear the a/c so even a a/c delete pulley may be in the way. I have to see

 

Bump,

Looks like it will not fit L98 Angle plug heads like AFR L98 angles, the plug is pointing right on the main tube.

Looks like it wont fit tall valve covers, and it looks to be for V-belt setups. AC will be right on the inlet housing

 

There go my plans. Nice manifold for someone though.

 

We can still make this happen Trade you that for my painted bumper and some cash? I do owe you for that

 

Not really going to have the cash to do the whole setup and i'm not one who likes to put parts on the shelf to be used later, kind of impatient. I'll end up maxing out another credit card to get it done and thats just not a good thing to do.

 

BUMP make offers

 

I have made turbo headers like this before and they are actually really efficent since the thick wall help keep the heat in. I used Schedule 40 Weld-els.

 

Bump anyone?

 

wanta trade for a SD harness and ecm you could use?

Only ask cuz I have some parts to add with your header and provoke my buddy to turbo his car. He wont spend $ on a setup so Figure its something I could say Hey look what I have you can use....lol

 

ok im lookin to do a single set up sience the twin headers wont b a bolt on could you pm me a link to where i can get them, and is it only one side and you make the crossover from the drivers side?

 

Sorry Chris, i'm going to repin my stock ecm wiring to use the 730 ecm.

Open to offer

 

Ok lets try this again. I had it on ebay 3 times and NO interest. So i'll try here again.

Please someone take this off my hands. 300 shipped

 

pm sent

 

sold thanks