[MA] LT1 Intake with all parts for SBC conversion
09-19-2010, 01:43 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 1999
Location: Ma
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Trans Am GTA
Engine: L98
Transmission: 700r4
LT1 Intake with all parts for SBC conversion
Selling my Lt1 intake. Came from a 96z28. It comes with fuel rails, fuel regulator, and map sensor. Just swap your injectors and throttle body over. I also have the EGR block off plates, angled shim for the distributor, throttle bracket for a 700r4 detent cable, and coolant hose adapters. I havent made the holes for the coolant outlets or the distributor on this intake. Was going to use it myself but now have carb'd 2ndgen. Looking to get $150
09-20-2010, 08:07 PM
#2
Junior Member
Join Date: Dec 2008
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
10-10-2010, 07:37 PM
#4
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 1999
Location: Ma
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Trans Am GTA
Engine: L98
Transmission: 700r4
Re: LT1 Intake with all parts for SBC conversion
From me..with an entire intake included lol. It was a group purchase from a board member a few yrs ago. Havent seen them avail since. Any machine shop should be able to make you one.
10-17-2010, 01:29 PM
#5
Member
Join Date: Dec 2009
Location: california
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 pontiac firebird formula
Engine: 5.7L HSR, 58mm tb,24lb inj.,lt4 cam
Transmission: 700r4,3000 stall,stage 2 shift
Axle/Gears: 10bolt 3.23 ratio
Re: LT1 Intake with all parts for SBC conversion
would you take 160.00 shipped too Fresno CA.?
Thread
Thread Starter
Forum
Replies
Last Post
