Gear Drive, push rods, LS1 valve springs
Thread Starter
Joined: Aug 2001
Posts: 1,589
Likes: 2
From: British Columbia
Car: 90 IROC 5.7 hardtop
Engine: L98
Transmission: T5 swap
Axle/Gears: Yup -- they still work
Gear Drive, push rods, LS1 valve springs
I have some parts laying about just taking up space
- new CAT GD-350R gear drive for SBC with knock sensor (quiet drive), $50
- used Comp Cams push rods 7.050 inch, used about 3500 miles, $50
- LS1 beehive springs with comp cams adaptors (for L98) and seals (also for L98), the springs are used about 20,000 miles on a stock cam, the other parts are new in box, $175 for springs, seals and retainers. The setup will work well for less than .500 lift cams
will ship to USA and Canada, buyer pays shipping
- new CAT GD-350R gear drive for SBC with knock sensor (quiet drive), $50
- used Comp Cams push rods 7.050 inch, used about 3500 miles, $50
- LS1 beehive springs with comp cams adaptors (for L98) and seals (also for L98), the springs are used about 20,000 miles on a stock cam, the other parts are new in box, $175 for springs, seals and retainers. The setup will work well for less than .500 lift cams
will ship to USA and Canada, buyer pays shipping
Thread
Thread Starter
Forum
Replies
Last Post
