I have a set of valve covers that I am replacing with another style. The valve covers will clear 1.5 and 1.52 rockers but according to Proform, will not clear 1.6. They feature two 1.25 breather holes. The two breathers in the picture will be shipped with the valve covers. The breathers have recently been replaced so they are good to go. I'm also going to send an oil cap in case you want to drill an oil fill hole in the valve covers or I can do that for an extra fee. I have recently polished them but I'll give them a quick polish before I ship them out.

I'm asking $65 plus shipping for the valve covers, two Proform breathers, and oil cap. Anywhere else, please PM as you'll need to pay for international shipping but I will ship internationally.

I have also have a stock TPI AC Delco fuel pump that was run for three years on my 383 HSR. I upgraded to the Walbro 255. Asking $40 shipped.

Thanks!

Pictures below.
There are water spots on this side as I was cleaning the engine that day.

 

Are they short or tall covers?

 

They aren't a short design, they are a tall-ish design. From the base of the valve cover to the top of them, they measure 3 3/4". However, due to the baffles on the inside the cover, 1.6 rockers will not clear.

 

Bump....will consider offers!

 

Going to the top!

 

Lowered price!

 

Just in case anyone is worried i wouldnt be a bit surprised if those cleared 1.6 rr with no issues. I am running stock LT1 Corvette covers from the 70s which are a shortish design and they cleared my 1.6 rr with only slight modification to the inside. I think mine only measured 2 3/8" up or there abouts.

 

Thanks for the information...I know Proform says no but its because of the breather baffles...they could be dented to clear most likely...thanks!

 

SOLD!

 

Congrats. If i didnt already have my covers i would have been all over those.

 

Thanks!