[AL] Very complete LT1 intake conversion setup
10-27-2016, 11:55 PM
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2003
Location: Montgomery, AL
Posts: 652
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Trans Am
Very complete LT1 intake conversion setup
I have a very complete LT1 intake setup for sale. It was mounted, but never used. I went with an LS motor, so this stuff sat on the shelf for quite a while.
LT1 intake is modified for the early heads, but the center holes can be modified for the later heads. The holes are welded, not epoxied like some conversions.
The intake is ported for a dual 58MM TB, which I have one for sale, a NEW Accel billet 1000CFM model in a separate listing here: https://www.thirdgen.org/forums/engi...dual-58mm.html I will cut a deal to whoever purchases both. The ports are port matched to a Fel-Pro 1205 for most 200cc heads.
All parts shown are included. Fuel lines to hook up to stock TPI hardlines, remote Tstat housing, rails, regulator, intake bolts, and throttle cable bracket. I will more firmly assemble the bolts and such prior to shipment.
Lots of work in this intake, looking for $400 shipped. I'll throw in the TB for $325, and knock $25 more off the manifold to make it $700 shipped. The TB includes the accessory kit with IAC motor that the other TBs don't include, it was $600 new, and comparable to the Holley billet TB that is $410 without the IAC kit or TPS. See my other listing for pics.
LT1 intake is modified for the early heads, but the center holes can be modified for the later heads. The holes are welded, not epoxied like some conversions.
The intake is ported for a dual 58MM TB, which I have one for sale, a NEW Accel billet 1000CFM model in a separate listing here: https://www.thirdgen.org/forums/engi...dual-58mm.html I will cut a deal to whoever purchases both. The ports are port matched to a Fel-Pro 1205 for most 200cc heads.
All parts shown are included. Fuel lines to hook up to stock TPI hardlines, remote Tstat housing, rails, regulator, intake bolts, and throttle cable bracket. I will more firmly assemble the bolts and such prior to shipment.
Lots of work in this intake, looking for $400 shipped. I'll throw in the TB for $325, and knock $25 more off the manifold to make it $700 shipped. The TB includes the accessory kit with IAC motor that the other TBs don't include, it was $600 new, and comparable to the Holley billet TB that is $410 without the IAC kit or TPS. See my other listing for pics.
Last edited by 85TransAm406; 10-28-2016 at 09:17 AM.
