found

delete

thanks

i've got a 305 out of my monte carlo ss. it's complete, but would need rebuilt. it's still sitting on the stand in my garage in williamsville....

I have one from a 89 gta It's a gm replacement engine with about 20mils and I have one from a 86 good runner with about 99,000 on it both are tpi motors I also have a 86 305 4bbl motor with about 80,000 on it. But I'm in Milwaukee.

I have a complete 305 Minus a few sensors and flexplate. Strong running too it out for a 350 swap near Peoria.

i need a carb one

bilms what is yours exactly?
and how much ?



911 how much ?
and what is it exactly ?
i really just need the complete bottom end but if its not a carb engine then i dont have a use for it


thanks

mines a stock '86 monte carlo SS motor....305 HO. I don't know much about them. I had a distributor that was going bad and it was running like crap. I just happened to have a motor that I was playing around building sitting on the engine stand and threw it in there on a whim. The stock 305 is still sitting on the engine stand all covered in 20 years of oily mess. They are sensored carbed motors from the factory. This one had an edelbrock on it when i pulled it. The E-brock went onto the motor in the car. It still has it's factory intake with it too. Not sure too much about it besides that...make an offer if you are interested.......

911 would you sell the pistons and rods out of your L69 HO 305 ?