looking for a 4 bolt 454 block Mark IV. Sometihng in halfway decent shape. the closer to stock bore, the better. Somewhere in new england would be good. May consider somewhere on the east coast if the price is right.

Dont need anything other than a block. Have some hooker comp sbc headers that I could trade + cash, or just cash.

 

I have a 1994 -454- (4 bolt) out of a 3500 GM truck. Put it on the side for a future project...but not really sure where I'm going with it. 3500 trucks and below use the same engine block as the cars.

Would be willing to trade it a for Chevy/GMC reg cab "donor" truck 1988-1995 (not running etc but with clean title). It must have solid cab corners, rockers and floor.

I want the C1500 or C2500 cab to put on my 3500HD chassis. The 1995 cab on it now is "very solid", has the new style interior which is nice also, but is a diesel. Want to put one of my F body TPI engines in the 95 and want to start with a cab that had a gas engine for the wiring, fuel tank & other misc.

I'm located in Champlain, NY..Vermont is 2 miles east, and Canada about 800 yards.

Motor was TBI and has serpentine setup.

Started a 3500HD web page at: www.3500HD.com

..